Trim Assembly Kits for Recessed Light Fixtures Recalled By Progress Lighting Due To Risk of Falling Parts

Recalled December 28, 2006 · CPSC recall 07071 · Trim

Hazard

Heat from the light bulb can cause the fixture's plastic trim to soften and melt, causing the trim and lens to fall. This can result in laceration injuries to nearby consumers.

Remedy

Consumers should stop using the recessed light fixtures containing the recalled trim rings immediately and contact Progress Lighting to arrange for installation of a replacement trim ring.

Units

About 12,800

Incidents / injuries

Progress Lighting has received four reports of the trims melting. No injuries have been reported.

Description

Trim assembly kits involved in this recall attach to recessed light fixtures installed primarily in bathroom ceilings. The trim assemblies include a 7 3/4-inch white plastic ring, a glass lens and a metal reflector. Affected models were made in China and have model numbers: 8009-60, 8010-60 or 8011-60. The model number and country of manufacture are located on a sticker attached to the inside and outside of the reflector. Models made in Mexico are not included this recall.

What to do

Consumers should stop using the recessed light fixtures containing the recalled trim rings immediately and contact Progress Lighting to arrange for installation of a replacement trim ring.

Contact

For more information, contact Progress Lighting toll-free at (877) 369-4548 between 8 a.m. and 5 p.m. ET Monday through Friday, or log on to www.progresslighting.com

Product

Trim Assembly Kits for Recessed Light Fixtures

Manufacturer(s)

Progress Lighting Inc., of Spartanburg, S.C.

Retailers

Electrical and lighting distributors nationwide from July 2006 through December 2006 for between $9 and $27.

Made in

China

Source: U.S. Consumer Product Safety Commission. Official recall notice on cpsc.gov →